Thursday, June 11, 2015

KNK Zing Air

I have been far too slow to get on the Klik n Kut and work out how to use it. Today I took the final plunge and used the cutting blade. I had several goes with the pen only, to work out how to place my fabric and set up the machine to cut in the right place.

I already had my SVG file ready to import into Make the Cut software. I deleted most of the shapes and kept the heart and two circles for testing.
Using 100% cotton quilting fabric backed with fusible applique paper I did a test cut on the minimum settings recommended. The fabric didn't quite cut through.

The only two things I could adjust were the amount of blade sticking through the holder and the force.
I adjusted the blade so it easily cut through two sheets of paper and I adjusted the force up to the higher recommended level.
I was thrilled that it worked perfectly. The fabric was cut through nicely and the paper backing was only just cut. My fabric pieces peeled off the paper backing very neatly.
The fusible paper backing is perfect to use with this machine because it sticks very well to the cutting mat.
As you can see, my mat isn't very clean. DH has been doing lots of testing and playing with light card. The paper backing stuck well though.


Here you can see where my first go didn't cut right through. On the new settings the fabric lifted out easily.



My KNK Zing Air settings were:
Yellow Fabric Blade - easily cuts through 2 sheets of paper. It just peeps out of the casing.
Speed - 9
Force - 135
Cuts - 2

I used a 12" virtual mat on portrait.
I chose the WYSIWYG setting for cutting.
I set the origin at the bottom right hand corner of the mat.

What is the point of all this?
I need to cut out 14 sets of applique pieces for 14 blocks of my Go Wild Quilt. This machine will make it very quick and easy.

My next experiment will be fabric on its own. I have read that the fabric tends to be dragged by the blade rather than sticking firmly. We shall see.

Happy Quilting ans Crafting,
Val


Related Posts Plugin for WordPress, Blogger...